How to set up your Snuggy Pod.

Play video

The video loads from YouTube when you press play.

1. 1

   Step 1: Lay the Pod flat

   Find the front entrance first. This helps you face the Pod the right way before any poles go in.

2. 2

   Step 2: Insert the long poles

   Push the three long poles through the zip access holes along the bottom of the Pod. They curve as you go and form the arch.

3. 3

   Step 3: Insert the short poles

   Slide the two short poles into the zip access points near the top. They stay straight and hold the Pod upright.

   Double or king? You'll have three short poles.
4. 4

   Step 4: Close all the zips

   Zip every access point fully closed. This locks the frame in place.

5. 5

   Step 5: Tie the corners

   Tie the ribbons at the base of the Pod around each leg of your bed frame, so everything stays put.

6. 6

   Step 6: Slide the mattress in

   Slide your mattress in through the front entrance and settle it into the base.

That's it, your Pod is ready.

Add bedding, a favourite teddy and some fairy lights. There's a hook in the roof to hang them from.

1. 1

   Step 1: Remove the mattress

   Slide it out through the front entrance.

2. 2

   Step 2: Untie the corners

   Undo the ribbons from each leg of the bed frame.

3. 3

   Step 3: Take out the poles

   Unzip every access point. Remove the short poles first, then the long poles.

4. 4

   Step 4: Roll and pack

   Collapse the Pod, roll the fabric and pack everything into the carry bag. It's ready to go wherever you do.